找回密码
 立即注册
搜索
热搜: 活动 交友 discuz
查看: 3370|回复: 0

High quality Repeater

[复制链接]

2

主题

0

回帖

8

积分

新手上路

积分
8
发表于 2018-11-14 09:15:43 | 显示全部楼层 |阅读模式
Mini UHF duplexer repeater 10mhz spacing for walkie talkie BJ-851


1.Specification of repeater

General
Frequency Range:400-490 MHZ ( Frequency spacing :10MHz)
Frequency Spacing10MHZ
Duplex Band Width1MHZ
Modulation TypeFM 16F3
Operating Voltage12-14V
Currentstandby current  :  0.3A       Rx current : 0.8A      Tx current :3.0A
Frequency Stability≥2.5 PPM
Channel Spacing25KHZ
Weight Approx 2kg                       

2.Specification of Duplexer
Frequency Range (MHZ)RX:453.5---456.5MHZ   TX:463.5---466.5MHZ
Frequency spacing10MHZ
Max Output Power (W)10W
Receiving End Insertion loss (dB)≤2dB
Transmitting End Insertion loss (dB)<1.5dB
Transmitting-Receiving End Isolation (dB) ≥65dB
Max VSWR1.5
Operating Temperature Range-30-----+60°C
Frequency StabilityApprox 2.5ppm/°C
Matched Impedance50Ω
Receiver
Simplex Sensitivity≥0.3uv(12dB SINAD)
Duplex Sensitivity<3dB
Squelch Sensitivity≥0.2uv
Selectivity-70dB
Spurious Radiation-75dB
Intermodulation Rejection-75dB
Residual Noise-45dB
DEMP FO6±3dB
Audio Output Power4.0W
Audio Distortion<5%                        
Working Modereceiving mode
Transmitter
Output Power5-10W                     
Spurious Radiation≤80dB                                      
Residual Modulation-45dB
Audio Distortion<5%            
Max Modulation5KHZ
Pre-emphasis Frequencies6±3dB               
Working ModeTransmitting Mode
CPU Controller
Automatic Repeater Setting
MIC and PTT control
PC Programming
CTCSS and DCS

Note:1.the repeater have MIC ,but it not standard accessories
         2.the repeater just can do 10mhz ,you should choose 10mhz from 400-490mhz ,like 410-420mhz,422-432mhz,445-455mhz and so on.
         3.the repeater software just can change channels frequency and CTCSS .but the factory should be in factory setting . if the repeater is finished ,you will can not change the frequency(like 410-420mhz,422-432mhz).
          4.the repeater need antenna .the antenna need to put in the highest place ,the signal will be good.
         5.the repeater need a cable to contact the antenna .the cable can not too long ,the cable will reduce the repeater power.
cable need -9 (is good ).





size



accessories




packing



High quality Repeater
website:http://www.bjtwowayradios.com/repeater/

您需要登录后才可以回帖 登录 | 立即注册

本版积分规则

快速回复 返回顶部 返回列表